This is a version just like the “Box with LIGHTS - one piece version” we have in the profile https://thangs.com/mythangs/file/948514, but without the modifications to accommodate the lights.
Printing settings:
Nozzle diameter: 0.4 mm Layer height: 0.25 mm Perimeters: 2 Top and bottom solid layers: 4 Prints with tree supports (an image is attached): This part is the most critical. We propose that the box be printed vertically because if it's printed lying down, removing the supports for the teeth can be a real challenge. The issues we encountered when printing it vertically are that the structure can bend slightly due to PLA shrinkage as it reaches the top. If this happens, the upper distance may be reduced, and as a result, the plates may not fit properly. Because of that, we have slightly scaled up the original model of the box in the X-axis to overcome these setbacks. Even if the distance at the top is reduced slightly, you can still comfortably accommodate the plates without any problems. We have tested it and it works fine. Anyway, we don't have this problem on the full version that can be printed with no supports. If you want access to our wall-hanging and compact box, you can support us on patreon.
Hope you enjoy this model, see you arround!
All Quimicafeina designs are protected by Copyright Law. By downloading, you have no right to sell any digital files or reproductions from those files.
To get access to all of our designs or for a commercial license to sell the physical prints of the files, you can support us on patreon.